Unisteer 8010650-02 Chevy II/Nova Power Rack & Pinion Kit 1962-67 User Manual
Page 7
pg. 7
655520
Steering Shafts
A steering shaft is required to make this kit work; a steering shaft is not included with this kit due
to the variances in column, engine, and header combinations. Generally, three U-joints and two
sections of shaft and a support are needed. Unisteer has three different shaft kits available for
this rack and pinion kit depending on what column (factory or an aftermarket) you are using.
Each kit includes three U-joints, two sections of shaft, and a bracket with support bearing. The
bracket has been made to bolt to the frame rail.
*If you decide to source your shafting supplies elsewhere, the pinion size on the rack is GM
17mm DD.
Pump Installation
A new GM Type II TC pump, made with the correct pressure and flow to run with this rack &
pinion is included in this kit. The pump comes with the pulley and mounting bracket installed onto
the pump.
1. The Pump Assembly bolts onto the lower driver side of the engine block. Use the bolts
provided along with the spacers. The longer spacer is for the upper bolt hole and the shorter
spacer goes in between the two brackets for the lower bolt hole. The lower bolts holes on the
pump assembly are grooved to allow for adjustment.