Unisteer 8010650-02 Chevy II/Nova Power Rack & Pinion Kit 1962-67 - Manual (Page 8)

pg. 8 655520
2. Establish a convenient location for the Remote Reservoir that is within reach of the lines.
You will need two (2) ¼”-20 Bolts of a length appropriate for what you are bolting the remote
reservoir too. For example, during our install, the remote reservoir was bolted beside the
radiator.
3. Install the stainless lines. The lines are attached as seen in the mock up diagram below. The
large #10 line (Line 1) runs from the elbow of the pump to the larger-bottom port of the
remote reservoir. The small #6 line (Line 2) with two straight fittings is the pressure line and
runs from the banjo fitting on the pump to the lower port of the rack & pinion. The other small
#8 line, (Line 3), runs from the smaller-bottom fitting on remote reservoir to the upper port of
the rack & pinion.
WARNING:
Make sure you have the lines running to the correct ports on rack & pinion, if you reverse
the lines it will blow out the seals on the rack & pinion and it will leak, such a repair is not
covered by the warranty.
Line 1
Line 2
Line 3