Unisteer 8012250-01 Ford Maverick Rack Kit 1970-77 - Manual (Page 11)

Page 11 657140
Assembly
6. To start the assembly, first install the supplied column tube bearing by tapping it evenly in with a
hammer. Next install the shaft insert at the very end of column shaft. Then install the supplied U-joint
so that the shaft is flush to the inside of the new joint. Drill and pin the joint shaft, and shaft insert in
place with the provided bit and roll pins. Finally slide the shaft through the bearing and turn until it
slides down on the internal column shaft. The u-joint should be up against the bearing when total
install is finished.
7. Once you have this done reinstall the column using all of the original components and hardware.
8. Install the new power rack and bracket loosely in place using the stock holes where the cross
member was with the new hardware provided. Your rack and pinion is also centered before shipping
and is marked; make sure not to move it off center or loosen the mounting blocks on the gear itself.