Unisteer 8012250-01 Ford Maverick Rack Kit 1970-77 - Manual (Page 15)

Page 15 657140
14. You can now torque the mounting bolts for your rack to 65 ft. lbs.
15. Install the outer tie rod ends and tighten to 45 ft. lbs. Adjust the toe by eye so you can drive to an
alignment shop. Tighten down the jam nut. Toe is adjusted with everything together by leaving the
jam nut loose and turning the rack inner end. Outer ends are installed with the curve pointing towards
the rear of the car.
16. When your lines are connected and the all hardware and fittings are torqued to spec you may top off
the fluid in the reservoir and start the car.
17. Let the car idle and turn the wheels back and forth slowly using small increments until you are turning
from lock to lock to remove air from the system.
18. Shut the car off and make sure you have no leaks and the level is full.
19. When your install is complete it will be necessary to have a professional alignment done.
If you have any questions or problems regarding this product please contact:
UNISTEER®
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Created on 12/02/2013
Last Revised 6/30/2014
Copyright © 2013 by Unisteer Performance Products All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying, recording or by any information storage and retrieval
system, without permission in writing from Unisteer Performance Products.