Unisteer 8012200-01 Ford Torino Big Block Rack Kit 1968-70 - Manual (Page 12)

Page 12 657110
10. Install the outer tie rod ends and tighten lock nut on steering arm to 45 ft. lbs. Adjust the toe by eye so
you can drive to an alignment shop. This is done by turning the inner end. You do not have to take off
outer end to adjust. Tighten jam nut once toe is set. Screw in Zerk fitting and grease.
11. The power steering pump is an easy install and comes with the pump brackets attached to it. If your
car was equipped with power steering you will need to remove the stock pump and brackets that held
it on the motor. Attach the lower short bolt with washer into bracket first and use the short spacer to
install it on the lower hole of the water pump. Then in the same way use the long bolt and spacer on
the upper hole of the bracket to the upper water pump hole. This large spacer goes in-between the
two pump brackets. Measure the belt length and install belt. Tighten the hardware.