Unisteer 8012170-01 Pontiac Gto Power R&P Kit 1964-67 - Manual (Page 11)

pg. 11
657070
2. The pump will mount as pictured below. Start by mounting the motor slotted hole first, and then move
to the two stationary holes. Use the long bolt & nut with large spacer that will go in between the
mounting bracket on the pump and the bracket on the motor at the motors slotted hole. The other
smaller spacer will go in-between the brackets on the lower pump hole.
3. It will be necessary to measure & purchase a new belt for pump assembly. Install belt, adjust tension,
and tighten pump bracket hardware to 25 ft lbs.
1
2 3
1
2
3
Pump
bracket Engine
bracket
Large Spacer
Small
Spacer