Unisteer 8012170-01 Pontiac Gto Power R&P Kit 1964-67 - Manual (Page 8)

pg. 8
657070
5. Thread the tie rod jam nut on each side first. Then after threading on outer tie rod ends connect outer
tie rods to steering knuckle. Tighten Outer end to 35 ft lbs. Adjust the rods by eye to keep front
wheels straight by turning the inner tie rod end. The toe adjustment is made with everything
connected. Once toe is set tighten jam nut.
6. Install power steering pressure line, smaller line, to lower port on rack assembly and tighten.
7. Install return line to upper port larger line to rack assembly & tighten.
8. Make sure lines are pointing toward front of car & route lines upward towards pump. Note: Make sure
lines do not interfere with pulleys, belts, etc.
Shaft Installation:
1. Cut the steering column shaft 7 1/4” from the furthest point on the bell of the rag joint as pictured
below.