UVP HybriCycler - Manual (Page 4)

HC-3000 HybriCycler Hybridization Oven 4
Set-Up Instructions
This equipment is not intended for interconnection with any other devices. Use of this equipment
other than intended may create a safety hazard and/or malfunction.
1. Plug the female end of the power cord
to the connection on the back of the
HybriCycler.
2. Insert your Hybridization bottle(s) into
the bottle carousel. Start by sliding the
bottle into the bottle carousel’s entry
hole at either end of the bottle
carousel.
WARNING: Do not insert a bottle into the
center tube. To do so would block air flow
and may result in a safety hazard and or
malfunction.
3. When the end of the hybridization
bottle is about to meet the bottle
carousel’s exit hole on the opposite
end, push the bottle down toward the
center of the bottle carousel, which
secures the bottle into the securing
rings. Then slide the hybridization
bottle through the bottle carousel’s exit
hole.
4. Open the HybriCycler’s door by
pressing down on the rear portion of
spring-loaded door latch. Slide the
bottle carousel into the hybridization
chamber ensuring that the front disk is
inserted into the groove of the carousel
guide. Close the door by squeezing the
door against the hybridization chamber
until the spring-loaded door latch
secures.