UVP HB-500 Minidizer - Manual (Page 5)

HB-500 Minidizer Hybridization Oven 5
Installing the bottles and tubes
Installing the carousel
Installation
The Minidizer Hybridization Oven has capacity for four 35x150mm bottles and eight 50ml or 15ml conical
plastic tubes. Combinations of multiple-sized bottles may be used at the same time.
1. To insert bottles or tubes into the carousel, gently
press them into the clips.
2. To insert bottle holder, begin by placing the large end
of the bottle holder into the slotted holder on the right
wall. Twist until the shaft locks into place, then slide
the rod end into the black holder on the left wall.
Compress the spring-loaded locking pins and rotate
until aligned with the spindle on the right wall.
NOTE: ALWAYS USE AN EVEN NUMBER OF BOTTLES
AND LOAD BOTTLES OPPOSITE EACH OTHER TO
BALANCE THE BOTTLE HOLDER. THIS PREVENTS
EXCESSIVE WEAR OF THE BEARINGS AND DRIVE
MOTOR.