UVP HB-500 Minidizer - Manual (Page 6)

HB-500 Minidizer Hybridization Oven 6
Temperature
Display: Press the
up and down
arrows to set the
temperature
Power: Press the
power switch to
the “I” position
operate the
temperature
Motor: Press the
power switch to
the “I” position
rotate the carousel
Operation
Caution: This equipment is not intended for interconnection with any other devices. Use of this equipment other than
as intended may create a safety hazard and/or malfunction.
Using the Hybridization Oven
1. Place the unit on a level working surface and provide adequate room in front of the door to allow easy
opening.
2. Plug the female end of the power cord into the back of the unit and the male end into a surge-protected
outlet.
3. To turn on the main power supply, press the Power switch toward “ON” on the right side of the control panel.
4. To turn on the motor control to rotate the carousel, press the motor control power switch to the “ON”
position.
Temperature Calibration
Controls
When the power is turned on, the
software revision number flashes for
several seconds. The display will then
show internal surface temperature (not
air temperature) for a few seconds. The
display will then revert to the factory
preset temperature of 30°C.
Altering the Temperature
Setpoint
The current setpoint value can be altered
using the “UP” and “DOWN” buttons
while the setpoint is being displayed. To
change the setpoint from normal mode,
proceed as follows:
1. Press then release either the “UP” or the “DOWN”
button. The LCD will flash to indicate that the displayed value is the current setpoint. If either button
is held down for more than several seconds, setpoint value will increase or decrease incrementally.
2. When the desired setpoint is reached, wait approximately five seconds without pressing either
button; the display will revert to normal mode showing the actual temperature. The new setpoint
becomes effective. When the unit is turned off and turned on again, the last used setpoint will be
displayed.
3. Allow sufficient time for warm-up prior to hybridization procedures.
Temperature Calibration
The hybridization oven is calibrated at the UVP factory. UVP recommends temperature recalibration be
performed at the UVP factory as recalibration by the user may void the warranty. To return the unit to UVP,
first obtain a RGA (Returned Goods Authorization) number from UVP.
Call UVP’s customer service department in Upland, California at (800) 452-6788 or (909) 946-3197 or
Cambridge, UK at +44(0)1223-420022 to obtain an RGA number or to inquire about temperature calibration.