UVP BioSpectrum Imaging System - Manual (Page 11)

BioSpectrum Imaging System 11
Zoom Lens Controller Setup
Assemble the lens controller’s connective
devices as follows:
1. Ensure that the zoom lens
controller components and
connections are assembled per the
picture at right.
2. Plug the power cable into the power
supply.
3. Plug the other end of the power
cable into an electrical outlet.
4. Wait until VisionWorksLS software
is loaded to plug the USB cable into
the computer.
Zoom lens controller and accompanying connective devices
UV Transilluminator Setup
1. Plug the power jumper cord into the back of the transilluminator.
2. Place the transilluminator on the tray.
3. Plug the other end of the transilluminator power jumper cord into the darkroom outlet on the inside
top rear of the darkroom as shown below.
LED White Light Illuminator Setup
1. Position the LED White Light Illuminator inside the darkroom so that the FRONT label is closest to
the door.
2. Plug the power cord into the darkroom outlet labeled with “LED illuminator plate” on the inside top
rear of the darkroom as shown below.
UVP Lens Controller
(pictured without
camera and lens)
Power Cable
Control Box
Power Supply
USB Cable