UVP MegaCam 800 Camera - Manual (Page 3)

MegaCam 800 Camera 3
Installation
The camera is controlled by VisionWorksLS software. Refer to your darkroom manual for additional system information
and the VisionWorksLS Software Manual (pdf file on the VisionWorksLS CD) or Help Files for software information.
MegaCam 800 Camera Kit with Motorized Fixed Lens
Installing on the BioSpectrum Imaging System
The photograph shows parts required for assembly of the camera kit with the automated/motorized fixed lens onto the
BioSpectrum Imaging System.
NOTE: Some components are preassembled at the UVP factory.
Set up the darkroom and unplug all components from the power outlet. Refer to the BioSpectrum Imaging
System Manual for more information.
The base mount (1) is attached to the top of the BioSpectrum darkroom at the UVP factory. If not, secure the
base mount to the darkroom with the long screws (not shown).
Attach the camera bracket (2) to the base (1) with the thumb nuts (3).
The camera (4) should be attached to the motorized lens controller (5) and motorized lens (6). Place the
camera/lens assembly over the base mount at the top of the darkroom and secure the camera to the bracket (2)
with the knob (7).
Connect the 15-pin camera power supply cord (8) to the camera well at the top of the darkroom.
Note: Although the picture shows a rectangular power supply, a power cord, and a pinned power connector, just
connect the pinned power connector coming from the darkroom to the camera. If upgrading the BioSpectrum
from one camera type to the MegaCam 800 camera, all power supply parts will be visible. In this case, the power
supply cord must be plugged into a wall outlet.
1
2
3
9
6
4
7
5
8
10
1. Base Mount
2. Camera Bracket
3. Thumb Nuts
4. MegaCam 800
5. Motorized Fixed Lens
Controller
6. Lens (f/1.2 shown)
7. Knob
8. Power supply
9. USB Cable
10. Camera Cover