UVP ChemiDoc-It 2 Imagers - Manual (Page 10)

GelDoc-It
2
and ChemiDoc-It
2
Imagers 10
GelCam 310 Camera with Motorized Lens
The GelCam 310 camera, zoom lens and diopter
are assembled at the UVP factory. (Note: Camera
may be a different size or color than shown)
1. Remove the cap from the lens (if in place).
2. Using the four brass thumb screws provided,
secure the bracket to the base of the
darkroom.
3. Slide the camera and lens assembly into the
camera bracket.
4. Insert and tighten the black thumb screw in
the central hole of the camera to secure the
camera to the bracket.
5. Plug the camera cable into the top of the
camera but do not plug in the other end of the
USB cable until VisionWorksLS software has
been installed.
6. Mount the lens control box on the hook
located at the back of the darkroom.
Tighten brass
thumb screws to
secure the bracket
to the base
Camera cable
Power switch for the Lens
Control Box
Central hole
Black thumb
screw