Hardware installation, Darkroom setup, Darkroom filter wheel setup – UVP iBox Scientia Small Animal Imaging System User Manual

Page 7: Cameras

Advertising
background image

iBox Scientia Small Animal Imaging System

7


Placing Filter at the Top of the
Darkroom

Hardware Installation

Darkroom Setup

1. Remove all the tape on the darkroom (filter wheel, doors, interior cables).

2. Detach the epi-light covers from the Velcro at the top of the darkroom and place the covers in a secure

location.

3. If included: place the UV transilluminator on the pull-out tray then connect the power cable to the interior

of the darkroom.

4. If included: place the Chemi Tray onto the top of the UV transilluminator.

5. If included: place the LED White Light Illuminator on top of the Chemi Tray.

6. Use a level to ensure that the darkroom is flat and make adjustments to the four feet of the darkroom if

necessary.

Darkroom Filter Wheel Setup

1. Ensure that the darkroom is in a fixed and permanent location

as filters may slide in movement.

2. Locate the filter wheel in the darkroom’s camera well at the

very top of the darkroom.

3. Each filter location in the darkroom is numbered for a

corresponding filter. By touching the sides of the filters only,
insert the filters into the proper location. (The numbers on the
side of the filter facing you and right side up.)

First position #1 = Leave Empty

Second position #2 = GFP filter (Rectangular filter,
503nm-523nm)

Third position #3 = RFP filter (Rectangular filter,
580nm-630nm)

Fourth position #4 = User Choice (filter provided if ordered separately)

Fifth position #5 = User Choice (filter provided if ordered separately)

Cameras

High sensitivity, scientific grade CCD cameras are designed for use with UVP’s iBox Scientia Imaging
Systems. This section covers the components and steps required to install and run UVP’s cameras. Every
camera has slightly different installation instructions. The following cameras are covered in this manual:

BioChemi 500

OptiChemi 610

Refer to the packing list for the camera included with the system.

Specifications

Specifications

BioChemi 500

OptiChemi 610

Type

CCD, Monochrome

CCD, Monochrome

Resolution

2048 x 2048

2184 x 1472

Bit Depth

16-bit

16-bit

Quantum Efficiency

55% peak

86% peak

Cooling

-

28˚ C, Absolute

-

50˚C from Ambient

Binning

Yes

Yes, 1x1 thru 10x10

PC Interface

USB

USB

Advertising
This manual is related to the following products: