UVP VisiDoc-It Imaging System - Manual (Page 7)

VisiDoc-It Imaging System 7

Insert and tighten the knob/washer in the
central hole in the camera to secure the
camera to the bracket.

Plug the camera cable into the top the
camera and the other end into a USB port on
back of the processor.

Connect the power cord from the
transilluminator to a surge protected power
outlet.

Connect the main power cord from the back
of the processor to a surge protected power
outlet.
Printer Setup
The thermal printer is an optional accessory. Proceed to the next section if a printer was not included with
the shipment.
Stylus and Holder
The screen is touch sensitive. If desired, use the stylus included with the system to operate the software
controls. For easy access to the stylus when operating the system, remove the tape from the back of the
holder and adhere it to the VisiDoc-It. Slide the stylus into the holder when not in use.
Connection for the
processor power
USB ports