UVP Benchtop UV Transilluminator - Manual (Page 5)

Ultraviolet Spectral Output Charts
Transilluminator Operation
Single UV Benchtop Transilluminator
Place the transilluminator on a level work surface. Be sure that an air space exists around the bottom of the
work surface. This space allows for the proper air circulation through the unit.
Plug the female end of the power cord into the transilluminator. For 230 volt models, or those requiring
special power cord connectors, ensure that the proper configuration of male connector or plug has been
properly connected to the power cord.
Plug the male end of the power cord into a properly grounded electrical outlet. The proper voltage of the
transilluminator is found on the product information label.
The transilluminator comes equipped with a UV Blocking Cover. If this cover is not in place or has been
removed, do not operate the unit without securing the cover. If the cover is missing, a UV Blocking Faceshield
must be worn to avoid UV exposure to the skin. UV Blocking Eyewear should be worn even with the cover
in place to avoid accidental UV exposure.
Benchtop UV Transilluminators Page 3