WarmlyYours FeelsWarm® Countertop Heating - Manual (Page 8)

7
4. ATTACH THE HEATING ELEMENT
A. With the heating element lying on the top of the counter with the white release paper facing up, peel the white release
liner off the heater— do not discard.
B. Reduce the size of the release liner into manageable pieces by ripping the white release paper into smaller sections,
approximately 6” X 24” (the size and shape of these sheets is not critical).
C. Immediately place the release liner sheets back down onto the sticky heating element (with shiny side touching the
heater). Place them onto the heater so that approximately 6” of the front edge of the heating element is exposed. This
process leaves a sticky portion of the heating element exposed to attach to the countertop while it is being manually
held and positioned under the counter.
D. Move the heater from the top of the countertop and begin attaching it to the underside of the stone counter while
keeping the white release liner on the heater. This is generally accomplished by sitting on the floor facing outward with
your back to the cabinet.
Align the heater under the counter, keeping it close to the front edge (1/4” to 1/2” from the edge). Lightly press the
heater down, so that it is flat and wrinkle free. The partial white release liner sheets prevent the entire heater from
sticking to the counter inadvertently while the heater is being aligned.
E. Once the front edge of the heater is positioned and wrinkle free, gently curl down the back edge of the heater and
remove the release paper. Then, lightly tack the entire heater in place.
F. Once the entire heater is tacked in place along the underside of the countertop, ensure it is wrinkle free. If so, then
proceed to press firmly over the entire heating element.
G. Using a dry rag to help provide evenly distributed pressure, press firmly across entire surface of the heating element.
Approx. 72”
Thermal Control Unit
Approx. 60”
Approx. 42”
Approx. 24”
Heating Element
Transformer
To 120V House Outlet
Installation Instructions SECTION 2