Bissell 27F6 - Manual (Page 8)

w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
O
perations
8
Before you clean
1. move furniture to another area if cleaning
an entire room (optional).
2. Vacuum area with a dry vacuum cleaner
thoroughly before deep cleaning.
3. Pretreating (optional):
3a. Pretreating is recommended to improve
cleaning effectiveness for heavily soiled
carpet in high traffic areas such as
entryway and hallways.
3b. BISSELL Tough Stain precleaner
spray the bissell tough stain
precleaner formula onto heavy traffic
areas, soiled areas or stains.
allow to penetrate for at least 3 minutes.
clean as normal, using the deep
cleaner in upright mode, following the
instructions below.
Upright cleaning mode
Filling formula & water tank
1. Remove tank from the base of the machine
by lifting up tank carry handle.
Note: This tank was designed with a flat
bottom so it can be easily filled.
2. unscrew the black cap and remove bottle
insert.
3. fill tank with hot tap water to the water fill
line. add two ounces of bissell 2X for-
mula to the tank.
4. Replace the bottle insert in the tank and
tighten the black cap. Replace the tank on
the deep cleaner.
Cleaning
1. Plug into a proper outlet and press the
power button. allow 1 minute for the hot
water heater to warm-up before cleaning.
2. While pressing the trigger, make one slow
forward wet pass and another one back.
ATTENTION:
some berber carpets have a
tendency to fuzz with wear.
Repeated strokes in the same
area with an ordinary vacuum
or deep cleaner may aggra-
vate this condition.
1.
3b.
2.