Bissell 27F6 - Manual (Page 9)

w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
9
O
perations
Cleaning continued
3. Release the trigger and make one slow
forward and backward pass over the same
area. Repeated passes will help aid in dry
time.
4. continue passes until cleaning area is
complete.
Note: Your machine may be equipped
with a circuit breaker that will auto-
matically shut off the brush if a large
or loose object is caught in the brush
roll. If that happens, be sure to unplug
your machine, remove the foreign
object, and then plug the machine
back in to reset the circuit breaker.
Empty dirty tank
1. When the dirty tank reaches the
“FULL” line on the tank it is time to
empty.
2. Remove dirty tank and carry to a utility
sink, toilet or outside (where you will
dispose of the dirty water).
3. to unlock the dirty tank lid, rotate han-
dle over the back of the tank. Remove
lid and pour out dirty water. Rinse out
dirty tank to remove any debris.
4. Replace top of tank, and rotate the
handle forward to lock in place on front
of tank.
Cleaning your machine
1. flush out machine of any remaining
residual solution.
fill the formula & water tank with hot
tap water and turn on your machine.
Recline handle and press the spray trig-
ger for about 15 seconds while making
forward and backward passes on car-
pet. continue without pressing the trig-
ger until there is no more water being
suctioned up.
turn off the machine and wrap the pow-
ercord. make sure the dirty tank and
the formula & water tank are emptied,
rinsed, and dried before the next use.
before you replace tank, clean all
debris from red filter screen.
Upright cleaning mode continued
CAUTION:
Do not overwet. Take care not
to run over loose objects or
edges of area rugs. Stalling
brush may result in premature
belt failure.
Tip:
make only one trip to the sink
by removing the entire por-
table cleaner. fill and empty
in the same trip.
2. 3. 4.
Tip:
for best results empty,
rinse and dry both tanks
before storing.
WARNING:
to reduce the risk of fire, electric
shock, or injury, turn power
off and disconnect plug from
electrical outlet before performing
maintenance or troubleshooting.