Blaupunkt Orlando CM 127 - Manual (Page 14)

14
Bass -Adjust from +7 to -7 at 2 dB/step using + to increase bass, - to decrease.
Treble - Adjust from +7 to -7 at 2 dB/step using + to increase treble,- to decrease.
Balance - Adjust balance from 9 (all the way left) using + to -9 (all the way right) using –.
Fader - Adjust fader from 9 (sound only from the front) using + to -9 (sound only from the rear) using –.
Loudness (LD)
Press LD to increase sound of low and high frequencies. LOUD icon appears. To cancel, press LD
again.
Radio Operation
Last Station Memory
Each FM bank and AM band has its own last station memory which holds last-tuned frequency for
that band or bank irrespective of whether that frequency is stored into a preset.
Selecting Bands
Press SRC as needed to access FM1, FM2, FM3/FMT, AM/AMT banks.
Seek Tuning
Press /\ or V to seek next receivable frequency. Tuning stops at frequency that fulfills sensitivity
requirements predetermined by sensitivity set through SENS/LD button.
Tuning Sensitivity (SENS)
Press SENS/LD for more that 2 seconds to switch between local (lo) and distant search sensitivity.
When “lo” is absent from the display, search sensitivity setting is distant.
Radio Reception Hints
• When listening to weak or distant AM stations, adjusting the Treble to minimum (-7) will reduce
noise and improve sound.
• In general, set SENS to distant tuning if in rural areas or where stations tend to be weak and
distant, and to local tuning when in metropolitan areas or areas where stations tend to be strong
and local.
Stereo Symbol
Stereo symbol turns on if a stereo station with an incoming signal of at least 20 dB
µ
V is received.
The unit gradually switches between mono to stereo automatically.
Manual Tuning
Press /\ or V for more than 1/2 second and frequency will go one channel/step in direction pressed.
Press and hold causes continuous manual tuning. Unit returns to seek tuning mode after 4 seconds
or after storing a station on a preset.
Preset Station Storage
After tuning desired frequency on desired band, press and hold a Preset Button for more than 2