WORX WU334 900W SDS Rotary Hammer Drill 240V - Manual (Page 9)

9
attacHing and ReMoving tHe cHuck
note: Ensure the Function Mode Selection Switch (3) is not in the
chisel rotation mode( ) or the chuck cannot be removed.
chuck icons:
“ “unlock
“ “lock
1) ReMoving tHe cHuck (See fig. B1)
Firmly turn the Rotary Sheath(b) as far as possible in the direction
noted by the unlock Icon“ “(clockwise) then pull the chuck(1) off.
After removing, clean the chuck and spindle of any debris fragments
and apply lubrication to the chuck for protection.
2) attacHing tHe cHuck (See fig. B2)
Firmly push the Rotary Sheath (b) onto the spindle. Turn it in the
direction noted by the lock Icon” “ (clockwise) , while pushing the
chuck until you hear a locking noise of a “click”.
Warning! When attaching the chuck make sure your fingers
don’t get pinched.
After locking, the Rotary Sheath will return to the initial position. Pull on
the chuck to make sure it has properly locked itself into place before
drilling.
adJuSting tHe auXiliaRy Handle (See fig. c)
For your personal safety we recommend using the auxiliary handle at
all times.
To adjust the handle, rotate the bottom of the handle anti-clockwise
and rotate the handle around the hammer collar until the handle is in
the desired position. Tighten fully.
anti-viBRation Handle
The Anti-vibration handle reduces the vibrations, making operation
more comfortable and secure.
2
3
4
c
C
B1
B2
I
II
b
I
II
b