3D Robotics X8 Ready-to-Fly 2013 - Manual (Page 2)

Attach propellers
2
Remove the rings from the propeller
packages. Select the ring with the
smaller internal diameter, and insert
it into the back of the propeller hub.
Remove the nuts and washers from the
motors. For the front-left and back-right
arms, add SFP propellers to the top motors
and SF propellers to the bottom motors
with the writing facing towards the sky.
For the front-right and back-left arms, add
SF propellers to the top motors and SFP
propellers to the bottom motors. Make sure
the writing on the propellers faces the sky!
Charge battery
3
Place the washer over the propeller, and
secure the nut tightly on top. Always ensure
that the propellers are fastened tightly to
the motors before flying.
+
–
LiPo 3A
Connect the charger to the power
adapter cable and a wall outlet.
Connect the red cable to the + port
and the black cable to the - port.
Set the charger to LiPo and 3A.
red
black
SF
SFP
SF
SFP
SF
SFP
SF
SFP