Rockwell Automation 20L-RESPRE-A1 PowerFlex 700L Frame 3A and 3B Input Filter Precharge Resistor Kit - Manual (Page 4)

4 PowerFlex® 700L Frame 3A and 3B Input Filter Precharge Resistor Kit (20L-RESPRE-A1)
Step 2: Drilling Installation
Holes (only required for
input filter panel without
pre-drilled holes)
If the input filter panel has no pre-drilled holes, drill four (4) mounting
holes at the dimensions shown in the drawings below in the right side panel
of the input filter. Use a #16 (4.5 mm/0.177 inch diameter) twist drill bit to
make the required diameter holes for the M6 x 16 mm (0.63 in.) long Taptite
hex head screws provided in the kit. Take care to prevent metal chips from
entering the enclosure.
!
ATTENTION: To avoid damaging critical electrical
components behind the input filter divider panel when drilling
holes, set the drill bit length to a maximum of 25.4 mm (1.0 in.).
Frame 3A
Right Side View 431.8 (17.00)
40.0 (1.57)
142.9 (5.63)
166.2
(6.54)
Dimensions are in millimeters (inches).
Frame 3B
Right Side View
142.9 (5.63)
247.6 (9.75)
232.3
(9.15)
431.8
(17.00)