Britax Y2K 03.A - Manual (Page 10)

Adjusting Handle Height:
To adjust the height of the handle, press and hold both
reflectors (K-1) while adjusting the height of the handle to
the desired position (K-2). Release reflectors when desired
position is achieved, to lock handle in place.
Reversing the Seat Unit:
To remove the seat unit, press the locks (L-3) down until
the unit is released. Pull the seat unit out of the slots by
lifting up and toward the rear of the stroller.
To install, position the seat unit on the chassis so that the
bars (L-1) on each side of the unit line up with the four
slots on the stroller chassis (L-2). Push the unit down and
toward the front of the stroller until the locks (L-3)
automatically engage. The seat unit is secured when the
red dot behind each lock is no longer visible.
Adjusting the Backrest:
Pull the handle (M-1) on the backrest and adjust (M-2) to
one of three positions. Verify that the backrest is fully
engaged in upright and reclined positions or lying flat in the
bed position.
K
L
8
Operating Instructions
M
P2296_R02lowres.qxd 2/6/2004 1:44 PM Page 10