Britax Y2K 03.A - Manual (Page 11)

Using the Footrest:
The position of the footrest can be adjusted by raising the
footrest and letting the support bar engage in the desired rung.
IMPORTANT: There is a red safety hook on the footrest.
When the footrest is raised to a horizontal position, this hook
must be pushed onto the support bar to lock it into place.
WARNING: Never use the stroller in reclined positions
without closing the opening by connecting the protection
net to the bumper bar. A child may slip into leg openings
and strangle.
Never completely detach protective net from stroller. To par-
tially detach protective net, undo the three snaps holding it
to the footrest. Remove bumper bar, then slide net off. Reattach bumper bar. Store partially
detached protective net under seat cushion when not in use.
To install the net, remove the bumper bar (page 7, J-1) and push it through the tunnel of the
protection net. Reattach the bumper bar to the seat armrests. Fit net over footrest so that the
net completely covers the leg area. Use snaps (5x) to secure lower portion of the protective net
around the footrest and armrest bars.
Using the Hood:
To install, insert tabs into slots on each side of stroller chassis. Verify that hood is secure.
The hood can be adjusted silently by pressing down on the top center point of the front rib of
the hood bar and bringing the hood into the desired position. You can also adjust the hood
without pressing down the hood bar. The noise this makes does not affect function or wear.
To remove hood, press buttons on each side, below the hood adjustment mechanism to release.
Using the Rain Cover:
In wet weather the rain cover can be stretched over the stroller. Align the ventilation hole near
the child’s head.
WARNING: Never leave your child unsupervised or allow your child to play with the plastic
rain cover. Always store in bag when not in use.
IMPORTANT: For proper ventilation, only use the rain cover for the duration of the rain.
Using the Safety Flashers:
To activate the safety flashers, first pull out the plastic tab. Press the flasher once to turn it on
and press again to turn it off.
To replace the batteries, remove the flexible flasher cover, the printed circuit board, then the
batteries. Insert the new batteries, making sure of correct alignment. Refasten the cover.
N
Operating Instructions
9
P2296_R02lowres.qxd 2/6/2004 1:44 PM Page 11