Rockwell Automation 1336S_F_T_E_R C-Frame Front End Conversion Kit - Manual (Page 2)

2 1336 PLUS, PLUSII, IMPACT, and FORCE C-Frame Front End Conversion Kit
Tools You need the following tools to disassemble and assemble the drive
•
C-frame Troubleshooting Guide 1336 PLUS-6.2, 1336 FORCE-6.2, or
1336 IMPACT-6.2.
•
Pliers.
•
Phillips screwdriver.
•
Standard screwdriver.
•
Torque wrench, metered in lb-in. or N-m.
!
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing,
servicing or repairing this assembly. Component
damage may result if ESD control procedures are not
followed. If you are not familiar with static control
procedures, reference publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.
!
ATTENTION: To avoid a shock hazard, assure that all
power to the drive has been removed before proceeding.
In addition, verify that the DC bus has discharged by
measuring across the “+DC” and “–DC” terminals of
TB1 with a voltmeter. The voltage should be 0.0VDC.
!
ATTENTION: Wear a wrist-type grounding strap
when servicing/handling all 1336-family drive printed
circuit boards. Failure to protect drive components
against ESD may damage internal drive components.
Refer to Electrostatics Discharge Precautions at the
beginning of Chapter 3 in the C-Frame Troubleshooting
Guide.