Brady X-Plus II - Manual (Page 85)

75 Configuration
Control Panel Parameters
1/11/07 X-Plus II User Guide 14068L-001 Rev. A
Initialize Flash Memory
This option erases all previously stored information from Flash memory.
Caution • This option completely erases the Flash memory.
To initialize Flash memory:
1. Press the right oval to select YES .
2. Enter the password. For instructions, see Change Password-Protected
Parameters on page 60 .
The display shows INITIALIZE FLASH?
3. Press the right oval to select YES .
The display shows ARE YOU SURE? .
4. Do you wish to continue?
• Press the left oval to select NO to cancel the request and return to the
INITIALIZE FLASH prompt.
• Press the right oval to select YES and begin initialization.
When initialization is complete, the printer automatically exits Setup
mode, and the control panel displays
PRINTER READY . If you exit
Setup mode while initialization is still in process, the control panel
display flashes between the phrases
CHECKING E: MEMORY and
PRINTER IDLE
.
Note • Depending on the amount of free FLASH memory,
initialization may take up to 1 minute to complete.
Table 9 • Printer Parameters (Sheet 12 of 26)
Parameter Action/Explanation
INIT FLASH MEM.
YES