Rockwell Automation 160 Low Profile Drive - Manual

BULLETIN 160 LOW PROFILE DRIVE
Choose an installation method:
• Install on 35mm DIN Rail.
• Install with screws. Recommended screw size is listed in the table below.
Mount bottom screws through mounting holes in fan bracket.
IMPORTANT: This instruction sheet contains information for the installation of the Bulletin
160 Low Profile Drive. The User Manual for the Bulletin 160 SSC Variable Speed Drive
(Series C) should be used as a supplement to this sheet.
ATTENTION: To guard against electrical shock, disconnect from power source before
installing or servicing.
ATTENTION: Do not touch drive surfaces. Temperatures are hot enough to cause severe burns.
ATTENTION: After system installation, remove the debris label from unit. Failure to remove
this label may result in overheating or nuisance tripping.
Description Metric English
Minimum Panel Thickness (14 GA) 1.9 mm 0.0747 in.
Mounting Base Screws M4 x 0.7 # 8-32
Mounting Torque 1.13 – 1.56 Nm 10 – 14 lb-in.
172.2
(6.78)
6.5
(.26)
80
(3.15)
60
(2.36)
151.6
(5.97)
Fan
Ground
Wire