Rockwell Automation 140U N-Frame CB Alarm Switch and Alarm Auxiliary Switch Combination - Manual (Page 5)

Page 5
d. If auxiliary switch(es) fails test, make sure that auxiliary
switch(es) module is properly seated in trip unit slots. If
auxiliary switch(es) appears to be correctly installed and
the problem persists, contact
Allen-Bradley.
2-1
2. Install circuit breaker.
2-1 3. Connect accessory leads as required (see Fig. 2-6).
Allen-Bradley assumes no responsibility for malfunction-
ing accessories installed improperly by the customer.
Rear Exiting Leads
(Preferred) Terminal Back
Opposite-Side
Exiting Leads Side Exiting Leads
Figure 2-2 Accessory Wiring Options
ASL
Switch
ASL
Switch
Actuator
Arm
Figure 2-3 Alarm (Signal) Lockout Switch Installation
Figure 2-4 Accessory Combination Installation
Auxiliary
Switch
ASL
Switch
Actuator
Arm
40752-094 (1) Effective 04/02