Rockwell Automation 1397 NEMA Type 1 Brake Installation Inst. - Manual (Page 2)

1397 NEMA Type 1 Dynamic Brake 2
1397-5.14 March, 1997
Duty Time (3) repetitive stops with an average of (1) stop every (10)
minutes.
Input Power DC Power Supplied from 1397 Drive.
Enclosure Type IP20 (NEMA Type 1) — Cannot be used in atmospheres
having corrosive or hazardous dust, vapor or gas.
Altitude Derating 1,000 meters (3,300 feet) maximum without derating.
Specifications
What These Instructions
Contain These instructions contain the necessary information to install &
configure a 1397 NEMA Type 1 Dynamic Brake. For additional
information on wire recommendations, brake parameters and related
function blocks, refer to the 1397 User Manual — Publication
1397-5.0.
Installation
!
ATTENTION: Electric Shock can cause injury or death.
Remove all power before working on this product.
The drive is at line voltage when connected to incoming AC
power. Before proceeding with any installation or
troubleshooting activity, disconnect, lockout and tag all
incoming power to the drive. Verify with a voltmeter than no
voltage exists at terminals L1, L2 and L3 on the drive input
power terminal block.
!
ATTENTION: This board contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing
or repairing this assembly. Component damage may result
if ESD control precautions are not followed. If you are not
familiar with static control procedures, reference publication
8000-4.5.2, "Guarding Against Electrostatic Damage" or any
other applicable ESD protection handbook.
IMPORTANT : The National Electrical Codes (NEC) and local
regulations govern the installation and wiring of the NEMA Type 1
Dynamic Brake. AC power wiring, control wiring and conduit must
be chosen and installed in accordance with these codes and the
information supplied in the 1397 User Manual — publication
1397-5.0.