Briggs & Stratton 1694919 - Manual (Page 13)

11
Initial Setup & Assembly
A
B
Figure 6. Bell Crank Installation
A. Chute Rotator Drive Cover Bolt
B. Chute Rotator Drive Cover
Install Hitch on to Tractor
1. Remove mower deck.
2. Install the bell crank (A, Figure 6) through the front
holes (B) of the hitch assembly.
NOTE: Make sure that the Lift Arm connection is to the
right side of the hitch assembly.
3. Place hitch on floor in front of tractor, with the hitch
mounting arms towards the rear of the tractor.
4. On underside of tractor frame, insert hitch support
shaft (A, Figure 7) as shown and secure, with the
cotter pin (B) on inside of frame. IMPORTANT – the
cotter pin must be located along the inside edge of the
tractor frame.
A
B
Figure 7. Hitch Support Shaft
A. Hitch Support Shaft
B. Cotter pin