Briggs & Stratton 1694919 - Manual (Page 15)

13
Initial Setup & Assembly
Install Snow Blade Lift Arm
1. Move the mower deck lift arm to the “LOWERED”
position.
2. Install the brass stand-off (A, Figure 10) at the top of
the mower deck lift arm (B), using bolt (C) and wash-
er (D).
3. Install the lift assist spring (E) from the rear edge of
the tractor frame to the brass “C” clip (F) on the
mower deck lift arm (B), if not already installed.
4. Slide the snow blade lift arm (G) underneath the trac-
tor and attach the lift arm to the stand-off (A). Secure
the lift arm with the hair pin (H). NOTE: Make sure to
position the washer (D) between the hair pin (H) and
the lift arm (G).
5. Attach the lower ball joint (I) to the bell crank (J).
Secure the lift arm with the hair pin (H).
A B
C
K
D
E
F
G
G
H
H
I
J
Figure 10. Belt Tension Lever
A. Stand Off
B. Mower Deck Lift Arm
C. Bolt
D. Lock Washer
E. Lift Assist Spring
F. C-Clip
G. Snow Blade Lift Arm
H .Hair pin
I.
Lift Arm Ball Joint
J. Bell Crank
K. Flat Washer