Rockwell Automation 1394-AM50_AM75 Replacing the 10 and 15 kW Axis Module - Manual (Page 3)

Publication 1394-5.15 - September 1998
Replacing the 10 and 15 kW Axis Module Fan !
9. Remove the screws and nuts that hold the fan to the fan housing.
Figure 5
Removing Fan Screws and Nuts
10. Remove the fan from the fan housing.
Installing the New Fan
To install the new fan:
1. Insert the new fan into the fan housing.
Figure 6
Fan Inserted into the Fan Housing
2. Peel the adhesive backing off of the new fan gasket.
3. Attach the new fan gasket to the fan housing in the direction
shown in Figure 7. Make sure you compress the slit in the gasket
to minimize the air gap in the gasket.
Figure 7
Attaching the New Fan Gasket
4. Press the gasket firmly to the fan housing to secure the gasket.
Fan Gasket
Slit