Rockwell Automation 1609 ENET - Manual (Page 2)

DIR 10000251453 (Version 00)
Copyright © 2012 Rockwell Automation, Inc. All Rights Reserved. Printed in China.
Additional Resources
1. Go to http://www.rockwellautomation.com/literature
2.
Go to Search, select Publication Number.
3. Type the Publication Number in the search box and press enter.
1609-IN012 (1609-D UPS Installation Instructions)
1609-IN013 (1609-B UPS Installation Instructions)
1609-IN014 (1609-SPD Installation Instructions)
1609-UM007 (1609 UPS Management Software User Manual)
1609-UM008 (1609 Network Management Card User Manual)
1609-UM009 (1609 UPS User Manual)
Setup Procedure
Note: The minimum requirement to operate the 1609 Network Management Card is to setup the Host
Name (default of 1609 Network). If you want to assign a static IP Address then please disable DHCP,
provide the IP Address, Subnet Mask and the Gateway.
Configure by EzSetting
The easiest way to configure the 1609 Network Management Card is by running the EzSetting Software.
You can find the software on the CD that shipped with the UPS.
1. Make sure both the dip-switches of 1609 Network Management Card are set to OFF position (normal
mode) to enable network transmission.
2. Make sure the workstation and the 1609 Network Management Device are in the same LAN. The
default device for the 1609 Network Management device is 192.168.1.100; therefore, set the workstation
device to 192.168.1.xxx.
3. Put the software CD in the CD-ROM drive and run the EzSetting Software.
4. On the top right corner select the appropriate LAN and press the Discover button to search for all the
devices in the same LAN. The 1609 Network Management device should display in the device list. If the
1609 Network Management device cannot be found, check the networking port UDP 3456 in the
Operating System (OP) and open it if it is blocked.
5. Select the device in the Device List to configure the network parameters then press the Modify button
to provide your account and password. The default account name and password are admin and
password, respectively.
6. Click the Configuration button and setup the essential network parameters.
7. Once the 1609 Network Management Card installation and configuration is complete, you are now able
to monitor and control the 1609 Network Management Card.
Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
Publication 1609-IN015A-EN-P - April 2012