BLACKHAWK! AUTOMOTIVE BH6221 - Manual (Page 4)

SAFETY INSTRUCTIONS
BEFORE USE
1. Inspect the jack before each use. Do not use if there are bent, broken or cracked components.
2. Verify that the product and the application are compatible, if in doubt call Blackhawk Automotive Technical Service
(816) 891-6390.
3. Read the operator's manual completely and familiarize yourself thoroughly with the product, its components and
recognize the potential hazards associated with its use before using this product.
4. Open the release valve counterclockwise no more than 2 full turns.
5. Locate and remove the oil filler screw with ram fully retracted (refer to Replacement Parts section).
NOTE: This will help release any pressurized air which may be trapped within the reservoir.
6. Ensure the oil level is just below the oil filler screw hole.
7. Reinstall the oil filler screw.
8. Pour a teaspoon of good quality air tool lubricant into the air supply inlet of the lift control valve.
9. Connect to air supply and operate for 3 seconds to evenly distribute lubricant.
10. Ensure that jack rolls freely and that the air pump operates smoothly before putting into service.
IMPORTANT: Replace worn or damaged parts and assemblies with Blackhawk Authorized Replacement Parts only.
NOTE: This product is fitted to accept the popular 1/4" PT air nipple. When installing 1/4" PT nipple of your choice,
ensure that thread tape or compound is used when servicing connections. To ensure dependable, trouble free
operation an inline air dryer and oiler is recommended.
4
• Leer, comprender, y seguir las instrucciónes antes
de utilizar el aparato.
• El manual de instrucciónes y la información de
seguridad deben estar comunicado en lengua del
operador antes del uso.
• No seguir estas indicaciónes puede causar daños
personales o materiales.
! ADVERTENCIA
To avoid crushing and related injuries:
NEVER work on, under or around a load supported
only by a jack. ALWAYS use adequately rated
jack stands.
Be sure all tools and personnel are clear before
lowering load.
! Safety Messages !
• Study, understand, and follow all instructions pro-
vided with and on this device before operating this
device.
• Do not exceed rated capacity.
• Use the device only on a hard, level surface.
• This is a lifting device only.
• Immediately after lifting, support the vehicle with ap-
propriate means such as jack stands.
• Never wire, clamp or otherwise disable the lift con-
trol valve to function by other than operator's hand.
• Do not modify or alter this device.
• Lift only on areas of the vehicle as specified by the
vehicle manufacturer.
• Only use attachments and/or adapters supplied by
the manufacturer shall be used.
• Do not use the device for any purpose other than
that for which it is intended.
• Failure to heed these markings may result in per-
sonal injury and/or property damage.
! WARNING ! WARNING