Rockwell Automation 1329M AC Induction Motors, 56-5000 Frame, User Manual User Manual
Page 2
2
AC Induction Motors
Contents
Acceptance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Storage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Uncrating and Inspection . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Floor Mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
V-Belt Drive . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Direct Connected Drive . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Electrical Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Thermal Protector Information . . . . . . . . . . . . . . . . . . . . . . . 6
Changing Rotation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Reduced Voltage Starting . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Allowable Voltage and Frequency Range . . . . . . . . . . . . . . 8
Cleanliness . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Condensation Drain Plugs . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Lubrication Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Relubrication Amounts . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Motor Troubleshooting Chart . . . . . . . . . . . . . . . . . . . . . . . 11
Parts Description Diagram . . . . . . . . . . . . . . . . . . . . . . . . . 13
General Information
Important: These instructions must be followed to ensure safe and
proper installation, operation and maintenance of the
motor. They should be brought to the attention of all
persons who install, operate or maintain this equipment.
Motors are all fully factory tested and inspected before shipping.
Damage during shipment and storage can occur. Motors not correctly
matched to the power supply and/or the load will not operate
properly. These instructions are intended as a guide to identify and
eliminate these problems before they are overlooked or cause further
damage.
Acceptance
Check carefully for any damage that may have occurred in transit. If
any damage or shortage is discovered, do not accept until an
appropriate notation on the freight bill is made. Any damage
discovered after receipt of equipment should be immediately reported
to the carrier.