Rockwell Automation 1608P HC-DySC Installation Instructions, 200 A - Manual (Page 19)

Rockwell Automation Publication 1608P-IN004A-EN-P - September 2013 19
Chapter
5
Specifications and Dimensions
Table 3 - Technical Specifications 200 A HC-DySC
Electrical Input/Output (Normal Mode—Static Switch)
Connection Configuration Series-connected with load. Under normal line condition, the static switch passes utility voltage directly to the load
Input Voltage 3-phase: 480V 1
Voltage Range ± 10%
Available Short Circuit Current 25kA
Current Overload (Static Switch) 150% @ 30Sec., 400% @ 5 Sec., 600% @ 0.5 Sec.
Frequency 50/60 Hz Auto Sensing
Frequency Range 48 -62 Hz
TVSS Output SPD, 40kA/mode
Efficiency > 99% @ 480V
Electrical Output (Sag Correction Mode - Inverter)
Output Voltage Pre-sag rms voltage
Voltage Regulation ± 5% typical, +5% / -13% of nominal max
HC-DySC Output Current 200 A
RMS
2
Not rated for DC loads; max. allowable 2% DC loading
Crest Factor (at nameplate rms load) 1.45
Voltage Waveform Sine wave
Voltage Sag Correction Times
Single Event
3 phase 87% to 50% Voltage Remaining 5 seconds
All three phases to zero voltage remaining 78 ms based on nameplate rated load with a power factor of 0.7
Multiple Event
Max Sag Correction Time 5 seconds cumulative usage
Sequential Sag Recovery 0 seconds (assuming cumulative run-time available)
Full Recovery Time Max 5 minutes
Mechanical
Enclosure Ratings NEMA 1 (IP20)
Cable Entry Top or Bottom
Cooling Filtered Forced Air
Access Front for servicing and connections
Audible Noise less than 60 dBA at 1m
Weight 1408 lb (639 kg)
Environmental
Ambient Temperature 0 to 40°C
Storage Temperature -40°C to 75°C
Relative Humidity 0 to 95% non-condensing
Altitude Rated current available to 1000m (3300ft). De-rate output current 10% per 1000m, from 1000m to 3000m (9900ft).
Safety and Compliance
Agency Approvals cULus Listed (UL 1012)
Standards Compliance Exceeds SEMI F47 Standard; IEEE Std C62.41.1 and UL 1449 3rd Ed. compliant
1. HC-DySC has not been evaluated for use in Corner Grounded or Ungrounded Delta Power Systems in systems rated over 240V.
2. When using HC-DySC with motor drive loads, either insert 3% to 5% line reactance at HC-DySC output or limit motor drive loads to 60% of HC-DySC rating