Rockwell Automation 1203-FM1 FLEX I/O SCANport Module User Manual
Page 3
Advertising
FLEX I/O SCANport
t
Module Installation Instructions
1–3
1203-5.7-- April 1996
Wiring
To wire the 1203 base used by this module, connect a SCANport
cable from the SCANport device to the desired channel.
SCANport cables are available in either Male–to–Male or
Male–to–Female configurations. You can connect cables of up to
10 meters (33 feet) between a SCANport device and any
SCANport peripheral.
If you use a port expander, you must subtract the cable length between any device
and the expander from the maximum cable length used to connect a peripheral.
The following diagram shows a typical network configuration:
SCANport devices
Flex Modules
"
Advertising