Rockwell Automation 1395/1396 Power Supply Kit - Manual (Page 2)

Instructions
1395/1396 Power Supply Kt
- 3. Disconnect the cable assembly and AC input wires from the Power Supply
Board. Remove and discard the board.
- 4. Position the new board (terminal block J1 to the right) on the panel. If
installing the board on a 346 to 980A drive, remove and discard the nylon
spacer from the bottom of the board. Secure the board using the hardware
previously removed.
- 5. Replace the cable assembly disconnected in step 3 with one of the following
supplied cables:
- 3.6 through 345A drives – short cable assembly
- 346 through 980A drives – long cable assembly
Discard the old cable and remaining supplied cable.
Important: Step 6 is required on power supplies that have 20 terminals on J1.
Proceed to step 7 if connector J1 has three positions as shown in Figure 2.
- 6. Locate the AC input wires on the existing connector (J1). These wires will
be labeled either PSJ1-1 through PSJ1-5 or J1-1 through J1-5.
Attach the new wire labels to the wires directly behind the existing labels.
Cut the wires from the old connector (J1), strip and attach to the new
connector (see Figure 2).
- 7. Attach connector to connector housing on the new power supply (if not
previously done).
- 8. On 3.6 through 345A drives, secure the swing-down panel in the upright
position. Check for proper drive operation.
Figure 2
Power Supply Input Connections
Power Supply Board
J1-5
J1-3
J1-1
J1
1
3
5
Publication 1395-6.5 – March, 1995 P/N 128990
Supersedes June, 1991 Copyright 1995, Allen-Bradley Company, Inc. Printed in U.S.A.
Algeria • Argentina • Australia • Austria • Bahrain • Belgium • Brazil • Bulgaria • Canada • Chile • China, PRC • Colombia • Costa Rica • Croatia • Cyprus • Czech Republic
• Denmark • Ecuador • Egypt • El Salvador • Finland • France • Germany • Greece • Guatemala • Honduras • Hong Kong • Hungary • Iceland • India • Indonesia • Israel •
Italy • Jamaica • Japan • Jordan • Korea • Kuwait • Lebanon • Malaysia • Mexico • New Zealand • Norway • Oman • Pakistan • Peru • Philippines • Poland • Portugal •
Puerto Rico • Qatar • Romania • Russia–CIS • Saudi Arabia • Singapore • Slovakia • Slovenia • South Africa, Republic • Spain • Switzerland • Taiwan • Thailand • The
Netherlands • Turkey • United Arab Emirates • United Kingdom • United States • Uruguay • Venezuela • Yugoslavia
World Headquarters, Allen-Bradley, 1201 South Second Street, Milwaukee, WI 53204 USA, Tel: (1) 414 382-2000 Fax: (1) 414 382-4444
Allen-Bradley has been helping its customers improve productivity and quality for 90 years. We
design, manufacture and support a broad range of control and automation products worldwide.
They include logic processors, power and motion control devices, man-machine interfaces,
sensors and a variety of software. Allen-Bradley is a subsidiary of Rockwell International, one of
the world’s leading technology companies.
With major offices worldwide.