Rockwell Automation 1397 200-300HP AC Line Disconnect Inst. - Manual (Page 6)

1397 300HP AC Line Disconnect 6
1397-5.27 October, 1997
❐ 8 Replace the disconnect’s bottom lug cover and tighten the (2)
screws holding it in place.
DS200 & DS300 Installation
(continued)
❐ 9 Replace the plastic line fuse cover.
❐ 10 Remove the disconnect’s top lug cover by loosening the (2)
screws holding it in place. Loosen the disconnect’s power line
box connector lugs and insert the incoming power cables
removed in
Step 1 .
❐ 11 Torque the cable lugs to the value listed on the disconnect label.
Replace the disconnect’s top lug cover and tighten the screws
holding it in place. Attach the line side label to the upper lug
cover as shown. Discard any other labels included with the kit.
❐ 12 Set the disconnect to the OFF position and restore incoming
power to the drive. Reset the disconnect switch by first moving
it to the OFF position, then to the ON.