Rockwell Automation 1772-MJ DATA MINI-PLC-2 FAM.PROG.CONTR - Manual (Page 12)

Step
5
Publication 1772Ć10.2 - March 1996
Connect Power to the
Processor or Power Supply
Connect Power to Processor
place tool here
insert wire
here
Strip 3/32 inch insulation from the end of the wire.
a
Insert screwdriver into the square opening and press down with it.
b
Insert the wire into the round opening on the front of the plug and
remove the screwdriver.
c
Connect Power Supply
120V
AC
L1
N
GN
1.5A 125V
SLOW BLOW
power wire
connects to
L1
neutral wire
connects to N
ground bus connects
to GND
Connect power cable to the ac or dc power supply's terminal strip.
c
5A 32V
NORM BLO
24V dc
24V
DC
+DC
COM
GND equipment
grounding
conductor
negative
positive
ac
dc
Loosen each terminal screw and place the appropriate wire under it.
b
Strip 3/8 inch insulation from the end of the wire.
a
Set the input voltage selector switch.
e
input voltage
selector switch