New Buck Corporation 85 - Manual (Page 25)

MODEL 85 INSTALLATION OF CLOSE CLEARANCE SHIELDS
(Optional)
1. Loosen the three (3) phillips head screws that secure the front cover plates to the front sides of the
stove.
2. Take rear close clearance shield and center with back and flushing with the bottom of the
stove using the self-tapping screws provided.
2. Remove self-tapping screws from rear of stove. Align holes in side shield with holes in rear
shield and attach to stove. NOTE: The rear of the side shields must go over the lip of the
rear shield.
3. You must measure one inch (1”) out from the side of the stove to the inside of the shield and main-
tain approximately one inch (1”) clearance while securing the shield to the back of the stove with
the 10-16x1/2” self tapping screws provided.
4. Before tightening the screws, insert the front end (Lip) of the side shield under the front
cover plate on the front side of the stove. Use the same step to install side shield on the op-
posite side of the stove.
5. Tighten all screws.
6. Place pipe shield on the back of the rear shield and align the two (2) holes on the parts and
secure with the phillips head screws provided.
NOTE: Use the figure above to install the Close Clearance Shields. Do not use page 23 in the Model 85 In-
stallation/Operation Owners Manual.
THREE (3) PHIL-
LIPS HEAD
SCREWS
(FRONT COVER
PLATES)
1”
LIP
FOUR (4) 10-16X1/2” SELF
DRILLING SCREWS
SIDE SHIELDS
REAR SHIELD
PIPE SHIELD
TWO (2) PILLIPS
HEAD SCREWS
23