Rockwell Automation 1747-DCM Direct Communication Module - Manual (Page 13)

Direct Communication Module 13
Publication 1747-IN005B-EN-P - March 2003
Installation
1. Disconnect power.
2. Align the full-sized circuit board with the chassis card guides. The 1747-DCM
must not be installed in slot 0. The first slot (slot 0) of the first chassis is
reserved for the CPU.
3. Slide the module into the chassis until the top and bottom latches are
latched.
4. Attach the RIO link cable to the connector on the front of the module.
5. Insert the cable tie in the slots.
6. Route the cable down and away from the module, securing it with a cable
tie.
7. Cover all unused slots with the Card Slot Filler, catalog number 1746-N2.
Removal
1. Disconnect power.
2. Press the releases at the top and bottom of the module and slide the module
out of the chassis slot.
3. Cover all unused slots with the Card Slot Filler, catalog number 1746-N2.
RIO Link Connector
Card Guide
Module Release