Rockwell Automation 1746-HSCE2 Multi-Channel High-Speed Counter Installation Instructions - Manual (Page 8)

8 Multi-Channel High-Speed Counter
Publication 1746-IN002A-US-P
Installing the Module
1. Make sure your SLC power supply has adequate reserve current capacity. The
module requires 250 mA at +5V dc.
2. Align the full-sized circuit board with the chassis card guide as shown below.
The first slot of the first chassis is reserved for the processor.
3. Slide the module into the chassis until the top and bottom latches catch. To
remove the module, press the release clips at the top and bottom of the module
and slide it out.
4. Cover all unused card slots with the Card Slot Filler, catalog number 1746-N2.
!
ATTENTION
Disconnect power before attempting to install, remove, or
wire the module.