Rockwell Automation 1738-APB ArmorPoint PROFIBUS Adapter, Series A - Manual (Page 6)

6
Publication 1738-IN015C-EN-E - February 2010
Mount the Adapter and I/O Bases
To mount the ArmorPoint adapter on a wall or panel, use the screw holes
provided in the ArmorPoint adapter.
Drilling Dimensions
To install the mounting base:
1. Layout the required points as shown in the Drilling Dimensions
drawing.
2. Drill the necessary holes for #8 (M4) machine or self-tapping screws.
3. Mount the adapter using #8 (M4) screws.
4. Ground the system using the ground lug connection in the I/O bases.
Note that the ground lug connection is also a mounting hole.
5. Mount the terminating base that was shipped with the adapter as the
last base in the backplane instead of the base that was shipped with
the I/O module.
Adapter
102 mm
(4.02 in)
56 mm
(2.2 in)
46.25 mm
(1.8 in) 51.9 mm
(2.0 in)
20.1 mm
(0.8 in)
51.9 mm
(2.0 in) 51.9 mm
(2.0 in)
20.1 mm
(0.8 in)
43769