Rockwell Automation 1771-IFE/C INSTL.INSTRUCTIONS ANALOG INPU - Manual (Page 5)

Analog Input Module 5
Publication 1771Ć5.45 - July 1997
!
ATTENTION: Remove power from the 1771 I/O
chassis backplane and field wiring arm before
removing or installing an I/O module.
•
Failure to remove power from the backplane or
wiring arm could cause module damage, degradation
of performance, or injury.
•
Failure to remove power from the backplane could
cause injury or equipment damage due to possible
unexpected operation.
Place the module in the card guides on the top and bottom of the chassis that guide the module into position.
Important: Apply firm even pressure on the module to seat it into its
backplane connector.
11
Snap the chassis latch over the
top of the module to secure it.
Swing the chassis locking bar
down into place to secure the
modules. Make sure the locking
pins engage.
1771ĆA1B, ĆA2B, ĆA3B1, ĆA4B Series B I/O chassis 1771ĆA1B, ĆA2B, ĆA3B, ĆA3B1, ĆA4B I/O chassis
17643
wiring arm
install
remove
horizontal bar
Attach the wiring arm (1771ĆWG) to the horizontal
bar at the bottom of the I/O chassis.
The wiring arm pivots upward and connects with
the module so you can install or remove the
module without disconnecting the wires. 1771ĆWG
2
Install the Module and
Field Wiring Arm