Replace the power supply – Rockwell Automation 1734-EP24DC Point I/O Expansion Power Supply Installation Instructions User Manual
Page 10
10 POINT I/O 24V dc Expansion Power Supply
Publication
1734-IN058B-EN-P - June 2005
1. Pull up on the RTB removal handle to remove the terminal
block.
2. Remove the module to the right of the 1734-EP24DC module
from its base unit.
3. Use a small-bladed screwdriver to rotate the DIN rail locking
screw to a vertical position.
This releases the locking mechanism.
4. Lift straight up to remove.
Replace the Power Supply
To install a replacement expansion power supply, proceed as follows.
WARNING
When you connect or disconnect the removable
terminal block (RTB) with field-side power applied,
an electrical arc can occur. This could cause an
explosion in hazardous location installations.
Be sure that power is removed or the area is
nonhazardous before proceeding.
42511