Rockwell Automation 1797-TB3S FLEX Ex Terminal Base - Manual (Page 12)

12 FLEX Ex Terminal Base Units
Publication 1797-5.1 - June 2010
5. Rotate the terminal base onto the DIN rail with the top of the rail
hooked under the lip on the rear of the terminal base.
Use caution to make sure that the female flexbus connector
does not strike any of the pins in the mating male connector.
6. For specific wiring information, refer to the installation instructions
for the module you are installing in the terminal base.
7. Repeat the above steps to install the next terminal base.
8. Be sure the flexbus connector cover on the last terminal base is in
place.
41108
Press down on the terminal base to lock it on the DIN rail. If the terminal base does not
lock into place, use a screwdriver or similar device to open the locking tab, press down
on the terminal base until flush with the DIN rail and release the locking tab to lock the
base in place.
41109
Gently push the flexbus connector into the side of the adapter (or proceeding terminal
base) to complete the backplane connection.