Rockwell Automation 1797-TPYS ControlNet Coax Taps - Manual (Page 9)

9
Publication 1797-5.18 - July 2006
• Insert two #8 or smaller screws with washers (not included) through the
holes and tighten into the surface behind the tap.
Connect Taps
After you have completed mounting your taps, you need to connect the taps.
Choose the tap connection procedure that best suits your installation requirements.
Connect Taps with a Jumper
You can connect Y-tap and T-tap bodies with a plug-to-plug jumper (1786-TJPR,
not included).
IMPORTANT
When connecting taps with 1786-BNCP barrel connectors, use an
intrinsically-safe sheath or 500V insulation-rated tape to cover the
metal connector. Use of the intrinsically-safe sheath or insulated
tape is required for intrinsically safe certification.
Tie Wrap Through Holes Screws Through Holes
Tie Wrap
Screws and
Washers
20083 20083
31666
T-tap Jumper Connections
Jumper