BT PARAGON 500 - Manual (Page 33)

33
BT Paragon 500 – Edition 4 – 10.05.04 – 5840
Switch answering machine on
If you forget to switch on your answering machine, you
can do it from another phone.
1. Dial your phone number and let it ring. After 20 rings,
your answering machine will switch on.
Check for messages
1. Dial your phone number. When you hear your outgoing
message, press . You will hear two beeps
2. Enter your 3-digit code. You hear a long beep for each
correct digit. If you have new messages, your machine
announces “You have (n) new messages”, and they are
played. Or you will hear “You have no new messages”.
Remote access
If you enter your security code
incorrectly you will hear 4 short
beeps and your answering machine
hangs up.
Time saver
If you have set the ring delay to
Time Saver, your answering
machine will answer after 2 rings if
you have new messages. If you do
not have new messages it will not
answer until 6 rings. This enables
you to hang up before you are
connected, saving you the cost of
a call. See page 30.
5840 Paragon 500 SMS UG [3] 10/5/04 5:14 pm Page 33